Operation - Delta 32-325 Manuel D'utilisation

ATTACHING THE CLEAR PLASTIC GUARD
To reduce the risk of injury, turn unit off and disconnect it from power source before installing and
removing accessories, before adjusting or when making repairs� An accidental start-up can cause injury.
1. Remove the protective cover from the guard.
2. Engage the two slots (B) Fig. 22 on the plastic guard (A) with the two spacers and screws (C) and secure the guard
by tightening the screws.
IMPORTANT: Gently bend the guard (A) outward slightly at the center when installing�
To reduce the risk of injury, tighten all assembly hardware at this point�
WRENCH STORAGE
A hole with a rubber grommet (A) Fig. 23 is provided on the top of the machine to store the supplied wrench (B).
B
C
To reduce the risk of injury, turn unit off and disconnect it from power source before installing and
removing accessories, before adjusting or when making repairs� An accidental start-up can cause injury.
OPERATING CONTROLS AND ADjUSTMENTS
STARTING AND STOPPING THE MACHINE
Make sure that the switch is in the "OFF" position before plugging in the power cord� In the event
of a power failure, move the switch to the "OFF" position� An accidental start-up can cause injury�
The on/off switch (A) Fig. 24 is located on the top of the motor. To turn the machine "ON", move the switch to the "ON"
position. To turn the machine "OFF", move the switch (A) to the "OFF" position.
LOCKING THE SWITCH IN THE "OFF" POSITION
IMPORTANT: When the machine is not in use, the switch should be locked in the "OFF" position using a padlock
(A) Fig. 25 with a 3/16" diameter shackle to prevent unauthorized use.
In the event of a power outage (such as a breaker or fuse trip), always move the switch to the "OFF"
position until the main power is restored�
B
C
Fig� 22
A

OPERATION

A
Fig� 24
B
A
A
12
Fig� 23
Fig� 25