Assembly ������������������������������������������������������������������������7 Español - Delta 32-325 Manuel D'utilisation

UNPACKING AND CLEANING
Carefully unpack the machine and all loose items from the shipping container(s). Remove the rust-preventative oil from
unpainted surfaces using a soft cloth moistened with mineral spirits, paint thinner or denatured alcohol.
Do not use highly volatile solvents such as gasoline, naphtha, acetone or lacquer thinner for cleaning your
machine�
After cleaning, cover the unpainted surfaces with a good quality household floor paste wax.
To reduce the risk of injury, turn unit off and disconnect it from power source before installing and
removing accessories, before adjusting or when making repairs� An accidental start-up can cause injury.
ASSEMBLY TOOLS REQUIRED
5/16" wrench (not supplied)
1/4" wrench (not supplied)
ASSEMBLY TIME ESTIMATE
Approximately two hours.
ACCESSORY 32-331 STAND
ASSEMBLING STAND
If you purchased the accessory 32-331 steel stand for
use with your boring machine, use Fig. 1 as your guide.
Align the holes in the legs with the holes in the braces,
insert a 5/16-18 x 5/8" (15.9 mm) carriage bolt through a
hole in the leg and the corresponding hole in the brace.
Place a 5/16" flat washer on the carriage bolt and thread
and hand-tighten a 5/16-18 hex nut on the carriage bolt.
Repeat this process for the thirty-one remaining holes.
NOTE: Mount all braces to the inside of the legs.
NOTE: The two top front and rear braces (A) are 13-1/2"
(343 mm) long. The two top side braces (B) are 16-1/2"
(419 mm) long. The two bottom front and rear braces (C)
are 19-1/2" (495 mm) long, and the two bottom side
braces (D) are 22-1/2" (571.5 mm) long. The four legs (E)
are 31-1/2" (800 mm) long.
NOTE: Hand-tighten the stand mounting hardware
until you attach the machine to the stand�
Attach the four plastic feet to the bottom of each leg.
ATTACHING THE MACHINE TO THE STAND
Place the machine on the stand, using Fig. 2 as a guide.
Align the four holes of the machine with the four holes on
the stand. Insert the 3/4" (19 mm) hex head screw
through the top of the machine and stand. Place a 5/16"
flat washer on the 3/4" (19 mm) hex head screw (A)
Fig. 2, followed by a 5/16" Lockwasher. Thread a 5/16-18
nut on the hex head screw and tighten securely. Repeat
this process for the three remaining holes.
ATTACHING THE MACHINE TO A SUPPORTING SURFACE
If you use the boring machine without the accessory stand, fasten the machine to a stable supporting
surface using suitable hardware (not supplied).
ASSEMBLY
7
B
C
D
E
D
C
E
A
A
B
Fig� 1
Fig� 2