Delta 32-325 Manuel D'utilisation page 11

ATTACHING THE OPERATING HANDLE
To reduce the risk of injury, turn unit off and disconnect it from power source before installing and
removing accessories, before adjusting or when making repairs� An accidental start-up can cause injury.
1. Remove the retaining ring (A) Fig. 17 and remove the connecting pin (B).
2. Insert the end of the operating handle (C) Fig. 18 into the head assembly and fasten the handle in place by attaching
the connecting pin (removed in STEP 1) through the hole in the end of the handle. Replace the retaining ring (A).
A
Fig� 17
ATTACHING THE BORING BITS TO
THE SPINDLES
To reduce the risk of injury, turn unit off
and disconnect it from power source before installing
and removing accessories, before adjusting or when
making repairs� An accidental start-up can cause injury.
NOTE: This machine will only accept bits with 10 mm
shanks.
1. Thread the thirteen supplied 5/16-24 x 1/4" (6.35 mm)
set screws (A) Fig. 19 part of the way into each
spindle.
2. Insert the boring bits (B) Fig. 20 (not supplied with
the boring machine) in the spindles (C). Push the bit
(B) in as far as possible and tighten the set screws
with the supplied T-wrench against the flats on the
bits.
NOTE: With the 13-Spindle Boring Machine, thirteen
bits are required (seven right hand rotation and six left
hand rotation). Insert a right-hand rotation bit in the
center spindle, and every other spindle to the right and
left. Insert the left-hand rotation bits into the remaining
spindles (Fig. 20).
ALIGNING THE BORING BITS
To reduce the risk of injury, turn unit off
and disconnect it from power source before installing
and removing accessories, before adjusting or when
making repairs� An accidental start-up can cause injury.
1. Place a flat piece of wood (A) Fig. 21 on the table
against the fence. Pull the operating handle down-
ward until ANY ONE boring bit (B) contacts the
wood. (A).
NOTE: If all boring bits (B) contact the top surface of the
wood at the same time, no alignment is necessary.
2. Hold the operating handle down with the one or
more bits touching the wood.
3. Loosen the set screw of any bit not touching the
wood and let the bit drop. After all bits are evenly
touching the wood, tighten the set screws.
B
A
11
C
A
C
B
B
Fig� 18
Fig� 19
A
Fig� 20
A
Fig� 21