Delta 32-325 Manuel D'utilisation page 14

SETTING THE FENCE STOPS
To reduce the risk of injury, turn unit off and disconnect it from power source before installing and
removing accessories, before adjusting or when making repairs� An accidental start-up can cause injury.
Two fence stops - one right (A) Fig. 30, and one left (B) - are supplied with your boring machine. A scale (D) with a
"0" mark in the center is provided on the fence. The fence extends 15" (381 mm) to the left and right. The stops (A)
and (B) can be moved anywhere along the fence by loosening the lock handles (C), moving the stops (A) and (B), and
tightening lock handles (C).
NOTE: The lock handles (C) Fig. 30 are spring-loaded. They can be repositioned by pulling out on the handle and
moving the hub of the handle on the nut located underneath the hub.
The left stop is shown in Fig. 31. The stop is positioned 12" (304.8 mm) to the left from the center of the fence. You can
read the distance on the English/Metric scale (D). If you don't use the stop (B), place the workpiece against the fence.
The stop (B) automatically moves to the rear allowing the workpiece to be placed flush against the fence.
B C
MACHINE USE
PROjECT EXAMPLE
Assignment: Bore a series of holes 1" (25.4 mm) in from the
edge of the workpiece. Bore an additional series of holes, in
line with the first series, 4" (101.5) in from the other edge of
the workpiece.
1. Set the left stop 1" (25.4 mm) to the left of the last
drill bit on the left side of the machine (E) Fig. 32. Set
the right stop 1" (25.4 mm) to the right of the last
drill bit on the right of the machine (F) Fig. 32.
Position the workpiece (G) against the fence with
the left edge of the workpiece against the left stop
(E). Turn the machine "ON", lower the handle, and
bore the holes.
2. The 13 holes are shown in Fig. 33, 1" (25.4 mm) in
from the edge of the workpiece (G).
NOTE: The right stop (F) Fig. 33 has been pushed back
so the workpiece can contact the fence surface.
3. Set the fence and table so that the fence is 4"
(101.6 mm) away from the boring bits and turn the
workpiece (G) Fig. 33 around so that the right edge
of the workpiece (G) is against the right stop (F). The
left stop can be pushed back so that the workpiece
can contact the fence sur face. Bore the additional
holes (Fig. 33).
C A
D
Fig� 30
E
G
14
B
D
Fig� 31
F
G
Fig� 32
F
Fig� 33