Connecting The Power Supply; Operating Procedures - Shizuoka Seiki VAL6 Daystar Manuel D'utilisation

■ Refueling
• Please use "kerosene" or "Fuel-Oil no heavier than No.2 (Diesel)" and do not use poor quality or foul fuel, to help avoid
ignition, operating, and other problems.
1 Remove the fuel cap and insert a handy
suction pump into the fuel tank.
2 Watch the fuel gauge while refueling.
When the gauge reaches the maximum
level, stop refueling.

■ Connecting the power supply

CAUTION
Make sure that the operating switch is
1
"OFF" , then plug the heater's power plug
into approved,
extension cord.
2 Plug extension cord into standard 120 volt/
60 Hz, 3-prong grounded outlet.

3-2. Operating procedures

CAUTION
Observations
• Do not use an adapter to change the power plug or power outlet from grounded (3
prongs or inlets) to ungrounded (2 prongs or inlets) as this improperly overrides the
safety function in grounding the heater by the provided power plug. Also if the power
cord or plug need to be replaced, please be sure to replace it only with genuine or man-
ufacturer-approved replacement parts.
grounded, three-wire
• If you detect smoke or a burning smell coming from the heater, turn the heater off im-
mediately to help prevent a fire, contact your dealer and the heater inspected before
further operation.
• More than three consecutive attempts to ignite the heater may cause a fire. If the heater
does not ignite after three consecutive attempts, stop trying and contact your dealer for
an inspection of the heater.
• When using the heater, be careful so that the floor surface (in front of it ) may not get
overheated.
• Do not operate the heater, while fuel tank is dirty and foul, to prevent poor ignition or
improper burning.
3 Tighten well the fuel cap, and wipe off any
spilt.
Extension Cord Size Requirement
• 6 to 10 feet (1.8 to 3 meters) long, use 18
2
AWG (0.75 mm ) rated cord
• 11 to 100 feet (3.3 to 30.5 meters) long,
use 16 AWG (1.0 mm
AC Outlet
Extension Cord
2
) rated cord
Connect
Grounded Power Pin
9