How To Use; Preparation For Operation - Shizuoka Seiki VAL6 Daystar Manuel D'utilisation

◆ Switch Section
ON
Misfire
!5 Overheat Preven-
tion System
!6 Electrical System
Protection (Fuse)
!7 Tip-over Switch
!8 Flame Monitor
Power shut down
Anomaly detection
system for fan motor
3

How to use

3-1. Preparation for operation

DANGER
CAUTION
8
@3
OFF
@4
Description of Safety Devices
Automatically extinguishes the flame should the heater overheat.
Operating condition: The misfire lamp lights and if the heater is operating, the fan will cool
Cuts off power to the heater should an electrical surge pass through the circuit caused
by damage to the heater, etc.
Operating condition: The whole operation stops.
Automatically extinguishes the flame when motion or an impact is detected during operation.
Operating condition: The misfire lamp lights and the post purge sequence will run for about
This automatically extinguishes the flame when ignition fails or flame goes out during the
operation. This monitor, when it detects any irregularity before ignition, automatically ex-
tinguishes the flame.
Operating condition: Misfire lamp is lit and Post-Purge continues for five (5) minutes.
When the power supply is restored after it shuts down during operation because of
blackout or other reason, in order to avoid a fire the heater can not restart automatically
even if the operation switch still remains "ON".
This automatically extinguishes the flame when some errors are detected in fan motor
such as cable disconnection or fan clogging.
• Never use highly flammable fuel like gasoline, to avoid fire.
• Never contaminate or mix fuels. For example, never contaminate kerosene with gasoline by
using a gasoline container to carry kerosene. Even a small amount of gasoline, or other vol-
atile fuels, in kerosene is hazardous. Store kerosene only in containers specifically labeled
and approved for kerosene and do not use the container for any other fuels or chemicals.
• Please refuel only while the heater is turned off and completely extinguished.
• Use only the electric power (voltage and frequency) specified on the model plate of the
heater to operate the heater. Using electrical power different from the specifications
may result in fire, electrical shock, and/or damage.
• Please confirm the ground/earth cable is properly connected, to prevent electrical shock.
• When disconnecting the electric power cord, be sure to always pull the plug out by it-
self. Do not pull out the plug by pulling on the power cord. Also, do not allow or cause
excessive force to be exerted on the cord at any time to avoid damaging it and causing
a fire or shock hazard. The heater should not be operated with the power cord in a taut
or tightened position to further avoid damage to the cord, accidental unplugging of the
electricity, and fire and/or shock.
@3 Operating Switch
This ignites or extinguishes the flame.
@4 Misfire Lamp
This lamp lights when the flame is extinguished due
to abnormal combustion, abnormal overheating, earth-
quake, or tumble.
down the heater for about 5 minutes (hereafter referred to as post purge).
5 minutes if the heater is in operation.
(Refer to pages 10.)