Use Of The Heat Shielding Mat; Operation With Portable Generator; Inspection - Shizuoka Seiki VAL6 Daystar Manuel D'utilisation

CAUTION

3-4. Use of the Heat Shielding Mat

To avoid unexpected fire or trouble, NEVER
use the heater on combustible flooring un-
less the heat shielding mat, which is avail-
able as an option, is used.

3-5. Operation with Portable Generator

WARNING
The heater operates within the voltage
range of 108 Volts to 132 Volts. Before plug-
ging the heater into the generator, the out-
put voltage of generator should be verified.
4

Inspection

WARNING
CAUTION
• Prior to each operation check the heater for signs of damage. Do not operate a damaged heater. Have it inspected and
repaired by a qualified service agency.
• Prior to each operation check the heater for signs of fuel leakage. Do not operate a heater with fuel leakage. Have it in-
spected and repaired by a qualified service agency.
• When the heater is controlled by another device (such as a thermostat or a timer), the
heater could turn itself on at any time.
• When the heater is controlled by another device, extra care must be taken to ensure that
the heater is not accidentally turned on without someone nearby who can immediately
attend to any problems when the heater is ignited, operating, and cooling off.
• Before operating the heater from a portable generator, please confirm that the genera-
tor has been properly connected to the ground earth. To operate the generator without
proper grounding may result in electrical shock. Please refer to the owner's manual
supplied by the generator's manufacturer.
• Never inspect or service the heater while it is burning, in operation, hot or plugged-in
to avoid any injury and/or trouble.
• Before starting any inspection or service, to avoid electric shock, please make sure the
heater is shut down and that the power cord is disconnected.
• When cleaning the heater, please wear gloves to prevent possible injury.
Observations
Heat shielding mat
If the voltage does not measure in this
range, the heater should not be plugged
into the generator.
11