Makita LXCV01 Manuel D'instruction page 6

Adjusting the shoulder strap
1
3
011118
To adjust the length of the shoulder strap, pull it out to
your desired length and pull the strap in the direction of
arrow as shown in the figure.
Connecting the hose
CAUTION:
Do not force the hose to bend it and/or stamp it.
•
Forcing and/or stamping the hose may cause
deformation or damage to the hose.
Do not pull the hose to carry the cleaner. Pulling
•
the hose may cause deformation or damage to the
hose.
B
1
2
1. Dust outlet
2. Power tool
011119
Insert the "A" end of the hose to the suction opening of
the cleaner and turn it clockwise all the way until it locks.
Attach the cuff on the "B" end of the hose and then
connect it to the dust outlet of an power tool.
1. Pull out
2. For shortening
3. For extending
2
A
Replacing the front cuff
Change the front cuff of the hose according to the dust
outlet size of a power tool you use.
1
2
011120
To remove the front cuff, hold the hose and turn it
counterclockwise.
To mount the front cuff, turn it clockwise and then
screw it in until it stops.
OPERATION
WARNING:
Do not use the shoulder strap when working in a
•
high place.
When using the cleaner as a stationary cleaner,
•
place it on a flat and stable surface
Vacuum Cleaner
011122
When using the cleaner as a portable cleaner,
cross-hanging the shoulder strap before the breast is
difficult to drop the cleaner.
6
1. Front cuff
3
2. Hose
3. Remove
4. Install
4