Technical Characteristics - Coleman 5430E Série Notice D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CAUTION
SERVICE SAFETY
• Keep all connections and fittings
clean. Inspect propane cylinder
and stove propane connections for
damage before attaching.
• During set up, check all connections
and fittings for leaks using soapy
water. Never use a flame. Bubbles
indicate a leak. Check that the
connection is not cross-threaded
and that it is tight. Perform another
leak check. If there is still a leak,
remove the cylinder and contact
Coleman for service or repairs.
• Use as a cooking appliance only.
Never alter in any way or use with
any device or part not expressly
approved by Coleman.
• Clean stove frequently to avoid
grease accumulation and possible
grease fires.
WARNING
BURN HAZARD
• Never leave stove unattended when
hot or in use.
• Keep out of reach of children.
WARNING
Not for home or
recreational vehicle use.
We cannot foresee every use which
may be made of our products. Check
with your local fire safety authority
if you have questions about use.
Other standards govern the use of fuel
gases and heat producing products
for specific uses. Your local authorities
can advise you about these.
• Never refill disposable cylinders.
• Use the preset regulator that came
with the stove. Do not attempt
to adjust.
• Use only Coleman
parts. During stove set-up, check all
fittings for leaks using soapy water.
Never use a flame.
Technical
Characteristics
Input: 10,000 BTU/h per burner
Category: Pressure regulated propane
Fuel: 16.4 oz. disposable propane cylinders
Regulator: 5430
accessories or
®
English - 3
To Set Up
DANGER
CARBON MONOXIDE HAZARD
• For outdoor use only.
• Never use inside house, camper,
tent, vehicle or other unventilated
or enclosed areas. This stove
consumes air (oxygen) and produces
carbon monoxide (CO). Do not use
in unventilated or enclosed areas to
avoid endangering your life.
NOTE: Use Coleman
disposable propane cylinders. The
LP-gas cylinder(s) used with stoves
must be constructed and marked in
accordance with the specifications for
LP-gas cylinders of the U.S. Department
of Transportation or Transport Canada,
CAN/CSA B339.
■ Remove components from carton.
(Fig. 1)
■ Open lid. (Fig. 2)
■ Position wind
guards as
desired. (Fig. 3)
16.4 oz.
®
Fig. 1
Fig. 2
Fig. 3

Publicité

Table des Matières
loading

Table des Matières