Technical Characteristics; To Set Up - Coleman 2000010870 Notice D'emploi

Réchaud à butane
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

DANGER
CARBON MONOXIDE HAZARD
• This stove is a combustion appliance. All combustion
appliances produce carbon monoxide (CO) during
the combustion process. This product is designed to
produce extremely minute, non-hazardous amounts
of CO if used and maintained in accordance with all
warnings and instructions. Do not block air flow into
or out of the stove.
• Carbon Monoxide (CO) poisoning produces flu-like
symptoms, watery eyes, headaches, dizziness, fatigue
and possibly death. You can't see it and you can't
smell it. It's an invisible killer. If these symptoms are
present during operation of this product get fresh air
immediately!
• For outdoor use only.
• Never use inside house, camper, tent, vehicle or
other unventilated or enclosed areas. This stove
consumes air (oxygen). Do not use in unventilated
or enclosed areas to avoid endangering your life.

Technical Characteristics

Input: 7,650 BTU/h
Category: Direct butane pressure
Fuel: Coleman CP250 250 g butane cartridge only
Only cylinder marked with the proper fuel type approved
for the appliance must be used.
The cylinder must be disconnected when the stove is
in storage.
4

To Set Up

NOTE: Use 250 g disposable butane cartridges only.
Do not connect to bulk systems. The butane cartridge(s)
used with this stove must be constructed and marked in
accordance with the specifications of the U.S. Department
of Transportation for Type 2P or 2Q fuel containers.
■ For outdoor use only.
■ Remove stove from carton.
■ Place stove on a stable, horizontal surface.
■ Do not use grill plates or pans that extend over the edge
of the cartridge compartment.
■ Make sure Lever
is in the "
"
position (otherwise
cartridge cannot
be installed).
■ Turn Control Knob
clockwise to ( )
position as shown.
■ Open the
cartridge
compartment.
■ Insert butane
cartridge as shown.
NOTE: Notch on
cartridge must be in
up position.
Cylinder supply system
must be arranged to
provide for proper fuel
withdrawal from the
operating cylinder.
■ Pull Lever down to "
".
■ Perform leak check where shown.
WARNING
Check for leaks using soapy water. Never use a
flame. Bubbles indicate a leak.

Publicité

Chapitres

Table des Matières
loading

Table des Matières