Installation
When installing the aerial inside
the vehicle (on the rear shelf)
Affix the metal sheet on as level a surface as
possible where the GPS aerial faces the win-
dow. Place the GPS aerial on the metal sheet.
(The GPS aerial is fastened with its magnet.)
Notes
! When attaching the metal sheet, do not cut
it into small pieces.
! Some models use window glass that does
not allow signals from GPS satellites to
pass through. On such models, install the
GPS aerial on the outside of the vehicle.
Metal Sheet
GPS aerial
Peel off the protective sheet
on the rear.
Clamps
Use clamps to secure the
lead where necessary inside
the vehicle.
Make sure the surface is free
of moisture, dust, grime, oil,
etc., before affixing the metal
sheet.
Note
The metal sheet contains a
strong adhesive which may
leave a mark on the surface if
it is removed.
Section
04
25
Engb