Checking/Replacing Battery Of Receiver Collar; Changing The Contact Points; Getting The Best Results; Fitting The Collar - EYENIMAL 450 REMOTE TRAINER Guide D'utilisation

To check the condition of the battery, turn on the remote control and look at the battery level indicator on the LCD screen. The symbols which
appear indicate the following:
Battery fully charged.
Weak battery: prepare to replace the battery.
Dead battery: your product switches to safety mode and the system
locks up. The battery must be replaced.
Replace the old battery with a new on as follows:
▪
On the back of the remote control, unscrew the screw and remove the battery
cover.
▪
Remove the old battery.
▪
Insert the new battery (3-V lithium CR2) paying attention to follow polarity
indicated on the battery housing.
▪
Put the battery cover back in place and retighten the screw.
▪
Check the remote control operates correctly.
● Checking/replacing battery of receiver collar
To check the condition of the battery, observe the On/Off indicator light located on the front of the receiver collar:

Flashes slowly green: battery fully charged.

Flashes quickly red: weak battery. Replace it with a new 3-V lithium CR 2 battery (See § First use from new: fitting the battery in the
receiver collar).
Check the receiver collar operates correctly.
● Changing the contact points
Two different series of contact points are supplied. The length of the contact points must be sufficient to have proper contact with the dog's skin,
enabling the device to operate correctly.
If you have a long-haired dog and the short contact points fitted to the collar in the factory are inadequate, remove and replace them with the
long ones supplied with the kit.
Carefully tighten them manually (do not use any key).
● How to check that your product is functioning properly
▪
Before doing so, make sure that the receiver collar is turned Off (indicator light off).
▪
Place the neon test lamp in contact with each of the contact points (by unscrewing them then by screwing them up in order to grip wires
of the lamp under the contact points).
▪
Turn On the remote control and receiver collar you want to test.
▪
Press the A or B key on the remote control to select the receiver collar you want to test (the letter A or B will appear on the LCD screen).
▪
Press the F or C button and modify the level of intensity of the static corrections: the test lamp must light with more or less intensity.
Renew the same procedure for each receiver collar you want to test.
● Getting the best results
The training instructions you give to your dog are sent from the remote control to the receiver collar(s) by radio waves.
These radio waves are sensitive and the range reaches approximately 450 yards (depending on geography and environment).
The performances of your product will be optimal if you respect the following recommendations:
▪
To obtain a good radio range, do not cover the antenna when you hold your remote control in your hand.
▪
The position of the receiver collar around the neck of the dog should be in the following way: the "On/Off" indicator light is visible and is
not in contact with the breast of the dog.
▪
Check the batteries (remote control and receiver collars) before using the unit and replace them as soon as the level of load is weak.
▪
The performances of the batteries decrease slightly under temperatures lower than 32 Ft. If possible, keep the remote control warm (e.g.
inside a pocket) before using it.
● Fitting the collar
The strap must be adjusted so that the contact points are in contact with the skin of the dog.
Collar adjustment is very important:
- If the strap is too loose, the collar is likely to move and repeated friction can irritate the skin of your dog. Furthermore, it will not function
correctly.
- If the collar is too tight, the dog will have breathing difficulties.
- 6 -
Replacing battery of the
remote control
Diagram 6
WARNING
Make sure the polarity is
correct