EYENIMAL 450 REMOTE TRAINER Guide D'utilisation page 4

Polarity "-" of the
battery
Diagram 4

Activate/deactivate the remote control
Remote control is supplied with battery fitted.
▪
Activate: Press for 1 second the On/Off red button
LCD screen.
▪
Deactivate: Press for 1 second the On/Off red button
To increase the battery life of the remote control, we recommend you to deactivate the unit if you are not using it for a long period.

Activate/deactivate the receiver collar
A magnet located in the remote control is used to either switch On or Off the receiver collar.
▪
Activate: move the remote control towards the collar so that the magnet position indicator on the remote control
comes into contact with the red mark located on the collar, hold for 1 second (ref. Diagram 5). The indicator light on
the collar will flash in green indicating that the collar is On.
▪
Deactivate: move the remote control towards the collar so that the magnet position indicator on the remote control
comes into contact with the red mark located on the collar, hold for 1 second (ref. Diagram 5). The indicator light on
the collar flashes from green to red and then goes out indicating the collar is Off.
If you have several collars, renew the same procedure for each one.
To increase the battery life of the receiver collar, we recommend you
deactivate the unit if you are not using it for a long period.

Coding of the remote control and receiver collar
Each remote control has its own individual radio operator code.
The coding of the remote control with the receiver collar enables the two units to work together.
IMPORTANT: before beginning the coding procedure, make sure no other person is using his 450 Remote Trainer or other products from the
EYENIMAL range close by. Your receiver collar could accidentally record the code of his remote control. If that occurs, re-code the remote
control with the receiver collar.
CODING PROCEDURE
Warning: if you have several collars, you have to code them one at a time.
1. Activate the remote control: Press for 1 second the On/Off red button
2. Press the A or B key on the remote control in order to select the collar you want to code (the letter A or B will appear on the LCD screen).
3. Receiver collar in position deactivated (indicator light off): move the remote control towards the collar so that the magnet position
indicator comes into contact with the red mark located on the receiver collar for 6 seconds. The indicator on the collar lights in fixed green
then flashes in red.
4. Move the remote control away from the receiver collar.
5. Press the button of the remote control. A beep sound is emitted; the receiver collar is then synchronized with your remote control.
If you have several collars, renew the same procedure for each one.
Polarity "+" of the
battery
located on the side of the remote control (ref. Diagram 2). Indications appear on the
located on the side of the remote control. The LCD screen is out.
Activate/Deactivate a
receiver collar with the
located on the side of the remote control.
- 4 -
Approach until coming
in contact those 2 areas
during 1 second
remote control
Diagram 5
Seal