Contents Of The Product; Description Of The Product; Checking/Replacing Battery Of Receiver Collar - EYENIMAL PFDRESTI291 Guide D'utilisation

User's guide
● Contents of the product
- 1 receiver collar equipped with short contact points and a strap
- 1 lithium 3-V CR 2 battery
- 1 neon test lamp
- 1 pair of long contact points
- 1 carry strap
- this user's guide
● Description of the product
● Fitting the battery in the receiver collar
▪
Unscrew the 4 screws of the top of the collar using a screwdriver.
▪
Insert the battery (3 Volt CR 2 Lithium) paying attention to follow polarity indicated on the battery housing (ref. Diagram 3).
▪
A beep sound (low pitch) is emitted, indicating the correct installation of the battery.
If you do not hear any beep after having inserted the battery, remove it immediately from its housing. Check the polarity before trying
again.
▪
Before putting the lid back in place, check that the rubber seal is in its groove.
▪
Screw up the 4 screws with care (do not over tighten them).
Polarity "-" of the battery
● Checking/replacing battery of receiver collar
To check the condition of the battery, observe the indicator light located on the front of the receiver collar:
▪
Battery fully charged: flashes slowly green.
▪
Weak battery: flashes quickly red.
Replace it with a new 3-V Lithium CR2 battery (See § First use from new: Fitting the battery in the receiver collar). Check the receiver
collar operates correctly.
Red mark:
area where the
On/Off switch
magnet is located
2 contact points
(short or long)
RECEIVER COLLAR
Diagram 2
Polarity "+" of the battery
On/Off indicator
+
Indicator of
radio reception
+
Battery level
indicator
Seal
Diagram 3