Changing The Light Bulbs; Power Interruptions; Moving Care; Troubleshooting - Whirlpool EH070CFXCQ Guide D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

7. Wash the inside walls with a solution of mild detergent in
warm water or 2 tbs (26 mg) baking soda to 1 qt (0.95 L)
warm water. Do not use abrasive or harsh cleaners.
8. Rinse well and wipe dry with a clean soft cloth.
9. Use a clean sponge or soft cloth and mild detergent in warm
water to clean outside of freezer, door liner, and gasket.
10. Rinse well and wipe dry with a clean, soft cloth.
11. Wax painted metal surfaces on the outside of freezer to
provide rust protection.
NOTE: Do not use wax on plastic parts. Wax may damage
them.
12. For models with a defrost water drain, you should remove the
hose adapter and replace the drain cover and the rubber
stopper in the bottom of the freezer.
13. Replace all frozen food.
14. Plug in freezer or reconnect power.
15. Refer to "Using the Control" section.

Changing the Light Bulbs

(on some models)
To replace interior light:
1. Unplug freezer or disconnect power.
2. Reach behind the light lens to remove bulb.
3. Replace bulb with a 15-watt appliance bulb.
4. Plug in freezer or reconnect power.
To replace indicator light:
1. Unplug freezer or disconnect power.
2. Carefully snap out light cover and assembly with a
screwdriver by inserting the edge of the screwdriver under
the metal edge of the light cover.
3. Unplug burned out signal light and replace it with a new one.
NOTE: Indicator lights can be ordered from your designated
service company.
4. Snap light cover and assembly into place.
5. Plug in freezer or reconnect power.
6

Power Interruptions

If the power will be out for 24 hours or less, keep the door closed
to help food stay cold and frozen.
If the power will be out for more than 24 hours, do one of the
following:
Remove all frozen food and store it in a frozen food locker.
If a food locker is not available, consume or can perishable
food at once.
After the power is restored, unplug the freezer for 30 minutes, to
allow the refrigeration system to equalize. During this time keep
the door closed whenever possible.
REMEMBER: A full freezer stays cold longer than a partially filled
one. A freezer full of meat stays cold longer than a freezer full of
baked goods. If you see that food contains ice crystals, it may be
refrozen, although the quality and flavor may be affected. If the
condition of the food is poor, dispose of it.

Moving Care

1. Remove all frozen food.
2. Unplug the freezer.
3. Clean it thoroughly.
4. Tape the freezer shut and tape the electrical cord to the
cabinet.
When you get to your new home, refer to the "Installation
Instructions" and "Freezer Use" sections for information on
installation and setting the controls.

TROUBLESHOOTING

Try the solutions suggested here first to avoid the cost of
an unnecessary service call.
Your freezer will not operate
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Is the power supply cord unplugged? Plug into a grounded
3 prong outlet.
Has a household fuse blown or circuit breaker tripped?
Replace the fuse or reset the circuit.
Is the temperature control set to a numbered setting?
Refer to the "Using the Control" section.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Eh155fxbqEh151fxtqEh185fxtqEh225fxtq

Table des Matières