Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CLEANING AND MAINTENANCE
•
Disconnect the unit from the power supply before cleaning.
•
Do not clean the appliance by pouring water.
•
Make sure that no water enters the lamp housing and other electrical components.
•
The refrigerator should be cleaned periodically using a solution of bicarbonate of soda and lukewarm
water.
•
Clean the accessories separately with soap and water Do not clean them in the dishwasher.
•
Do not use abrasive products, detergents or soaps. After washing, rinse with clean water and dry
carefully. When you have finished cleaning, reconnect the plugto the mains supply with dry hands.
•
Clean the condenser with a broom at least twice a year. This will help you to save on energy costs
and increase productivity.
!! The power supply must be disconnected.
Defrosting the Your Freezer
•
Small amounts of frost will accumulate inside the freezer, depending upon the length of time for which
the door is left open or the amount of moisture introduced. It is essential to ensure that no frost or ice
is allowed to form in places where it will affect the close fitting of the door seal. This might allow air to
penetrate the cabinet, encouraging continuous running of the compressor. Thin frost formation is quite
soft and can be removed with a brush or plastic scraper. Do not use metal or sharp scrapers, mecha-
nical devices or other means to accelerate the defrosting process. Remove all dislodged frost from the
cabinet floor. It is not necessary to switch off the appliance for the removal of thin frost.
•
For the removal of heavy ice deposits, disconnect the appliance from the mains supply and empty the
contents into cardboard boxes and wrap in thick blankets or layers of paper to keep cold. Defrosting
will be most effective if carried out when the freezer is nearly empty and should be carried out as
quickly as possible to prevent undue increase in temperature of the contents.
•
Do not use metal or sharp scrapers, mechanical devices or other means to accelerate the defrosting
process. An increase in temperature of frozen food during defrosting will shorten the storage life. If the
contents are well wrapped and placed in a cool area they should keep for several hours.
•
Dry the inside of the compartment with a sponge or a clean cloth.
•
To accelerate the defrosting process, place one or more bowls of warm water in the freezer compart-
ment.
•
Examine the contents when replacing them in the freezer and if some of the packages have thawed
out they should be eaten within 24hours, or be cooked and re-frozen.
•
After defrosting has finished, clean the inside of the appliance with a solution of warm water with a
little bicarbonate of soda and then dry thoroughly. Wash all removable parts in the same way and re-
assemble. Reconnect the appliance to the mains supply and leave for 2 to 3 hours on setting number
3 before introducing the food back into the freezer.
TRANSPORTATION AND CHANGING OF
INSTALLATION POSITION
Transportation and changing of Installation position
•
The original packages and foamed polystyrene (PS) can be retained if required.
•
During transportation, the appliance should be secured with a wide string or a strong rope.
The instructions written on the corrugated box must be followed while transporting.
•
Before transporting or changing the installation position, all the moving objects (ie, drawer, Ice trays,
...) shouldbe taken out or fixed with bands in order to preventthem from getting damaged.
!! Carry your freezer in the upright position.
Repositioning the door
•
It is not possible to change the opening direction of your fridge door, if the door handles on your fridge
are installed from the front surface of the door.
•
It is possible to change the opening direction of the door on models without any handles.
•
If the door opening direction of your fridge can be changed, you should contact the nearest Authorised
Service to have the opening direction changed.
EN - 43
Publicité
Table des Matières
