Changing The Light Bulbs; Power Interruptions; Moving Care - Whirlpool EH050FXMQ00 Guide D'utilisation Et D'entretien

3. For models with a drain system:
Remove the drain cover by pulling it straight out. Then insert
the hose adapter (provided) into the drain outlet. Remove the
rubber stopper from inside the bottom of the freezer. Place a
pan under the drain, or attach a hose to the threaded end of
the hose adapter and direct the water into a separate drain.
NOTE: Check the drain pan frequently to avoid water
overflow. Have a second pan handy for easier emptying.
For models without a drain system:
Remove water using a sponge or baster to remove excess
water from the freezer bottom and empty water into a large
pan.
4. Place pans of hot water in freezer with lid open to speed
melting. Directing air from an electric fan into freezer will also
help. Do not place fan or any electrical device in freezer.
5. Use a plastic scraper to remove frost.
NOTE: Do not use an ice pick, knife, or other sharp-pointed
tool to defrost freezer. Damage can occur.
6. Wipe water from walls with a towel or sponge.
7. Wash the inside walls with a solution of mild detergent in
warm water or 2 tbs. (26 mg) baking soda to 1 qt. (0.95 L)
warm water. Do not use abrasive or harsh cleaners.
8. Rinse well and wipe dry with a clean soft cloth.
9. Use a clean sponge or soft cloth and mild detergent in warm
water to clean outside of freezer, door liner, and gasket.
10. Rinse well and wipe dry with a clean, soft cloth.
11. Wax painted metal surfaces on the outside of freezer to
provide rust protection.
NOTE: Do not use wax on plastic parts. Wax may damage
them.
12. For models with a defrost water drain, you should remove the
hose adapter and replace the drain cover and the rubber
stopper in the bottom of the freezer.
13. Replace all frozen food.
14. Plug in freezer or reconnect power.
15. Refer to "Using the Control" section.

Changing the Light Bulbs

(on some models)
To replace interior light:
1. Unplug freezer or disconnect power.
2. Reach behind the light lens to remove bulb.
3. Replace bulb with a 15-watt appliance bulb.
4. Plug in freezer or reconnect power.
To replace signal light:
1. Unplug freezer or disconnect power.
2. Carefully snap out light cover and assembly with a
screwdriver by inserting the edge of the screwdriver under
the metal edge of the light cover.
3. Unplug burned out signal light and replace it with a new one.
NOTE: Signal lights can be ordered from your designated
service company.
4. Snap light cover and assembly into place.
5. Plug in freezer or reconnect power.

Power Interruptions

If the electricity in your house goes off, call the power company
and ask how long it will be off.
1. If the power will be out for 24 hours or less, keep freezer
closed to help foods stay frozen.
2. If the power will be out for more than 24 hours:
a) Remove all frozen food and store it in a frozen food
locker.
b) Place 2 lbs (.907 kg) of dry ice in the freezer for every
cubic foot (28.32 L) of freezer space. This will keep the
food frozen for 2 to 4 days.
c) If neither a food locker nor dry ice is available, use up or
can perishable food at once.
REMEMBER: A full freezer stays cold longer than a partially filled
one. A freezer full of meat stays cold longer than a freezer full of
baked goods. If food contains ice crystals, it may be refrozen,
although the quality and flavor may be affected. If the condition
of the food is poor, dispose of it.

Moving Care

1. Remove all frozen food and pack it in dry ice.
2. Unplug the freezer.
3. Clean it thoroughly.
4. Tape the freezer shut and tape the electrical cord to the
cabinet.
When you get to your new home, refer to the "Installation
Instructions" and "Freezer Use" sections for information on
installation and setting the controls.
OR
OR
7