English
Unit Features And Use
Initial Setup
Once you have plugged the unit into an electrical outlet, let the unit run for at
least 30 minutes to acclimatize itself before making any adjustments. During this
time, depending on the internal temperature, the red or white wine light will stay
on for the upper compartment and red or white wine light will stay on for the
lower compartment. The LED display will show the current internal temperature.
Temperature Adjustments:
• Wine cellar(HVFE040BBB): It can be set to any temperature between
39˚and 65˚F
wine storage requirements.
Wine/Beverage center(HBCW100ABB):
be set to any temperature between 46˚and 65˚F; the lower compartment
can be set to any temperature between 34˚and 62˚F.
To set the temperature hold the "Set" button for about 3 seconds.
You will notice the temperature display blink for the upper compartment.
Press the up or down arrow button to increase or decrease the
temperature setting. Once the desired temperature is attained, press
the "Set" button. Doing this, the electronic control panel will memorize
the setting. The temperature display will revert back to display the inside
temperature. It may take some time to reach the set temperature.
• Once the temperature is set for the upper compartment, you will
notice the temperature display blink for the lower compartment.
Again press the up or down arrow button to increase or decrease the
temperature. Once the desired temperature is attained, press the "Set"
button. Doing this, the electronic control panel will memorize the set-
ting. The temperature display will revert back to display the inside
temperature. It may take some time to reach the set temperature.
fig. # 1
• The unit is preset from the factory to automatically accommodate
temperature requirements for red or white wines.
6
in either of the compartments to accommodate your
Red
White
Upper
See fig. # 1
The upper compartment can
88
88
Red
White
˚F
˚F
Lower
Light
Set