Before First Use - Electrolux ESI5205LOX Notice D'utilisation

10 www.electrolux.com
1. Make sure that the programme
marker on the knob is in on/off
position.
2. To enter the user mode, press and
hold Delay. At the same time turn the
knob counterclockwise until the
programme marker indicates the first
programme. Release the Delay when
the indicators Start and on/off start
flashing.
• The intermittent flashing of
shows the current setting, e.g. 5
flashes + pause + 5 flashes =
level 5.
3. Press Delay repeatedly to change
the setting. Each pressing of Delay
increases the level number. After
reaching level 10, the count starts
again from level 1.
4. To confirm the setting, turn the
programme knob until the
programme marker is again in on/off
position
6.3 AirDry
AirDry improves the drying results with
less energy consumption.
During the drying phase, the
door opens automatically
and remains ajar.

7. BEFORE FIRST USE

1. Make sure that the current level of
the water softener agrees with the
hardness of the water supply. If
not, adjust the level of the water
softener.
2. Fill the salt container.
CAUTION!
Do not try to close the
appliance door within 2
minutes after automatic
opening. This can cause
damage to the appliance.
AirDry is automatically activated with all
programmes excluding
applicable).
CAUTION!
If children have access to
the appliance, it is advised to
deactivate AirDry as opening
the door may pose a danger.
How to deactivate AirDry
The appliance must be in programme
selection mode.
Make sure that the programme marker
on the knob is set to on/off position.
1. To enter the user mode, press and
hold Delay. At the same time turn the
knob counterclockwise until the
programme marker indicates the first
programme. Release Delay when the
indicators Start and on/off start
flashing.
2. Turn the knob counterclockwise until
the programme marker indicates the
second programme.
• The indicator
current setting: on = AirDry is
activated.
3. Press Delay to change the setting.
• If the indicator
is deactivated.
4. To confirm the setting, keep turning
the programme knob until the
programme marker is back in the
on/off position.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any
processing residuals that can still be
inside the appliance. Do not use
(if
shows the
is off = AirDry