Fortress Building Products Al13 HOME Instructions D'installation page 8

Fig. 1
Measure the panel opening
Check measurement with top
OTP & PROUD POST: CUTTING DOWN PANELS
Step 1. Measure & Mark Panels Where Cuts Will Be Made
1� To ensure panel is symmetrical, take the measurement found
on page 7 step 6 and divide it in half� Then cut equal lengths
from both ends�
2� Find the center of the panel and measure out half of the length
each direction�
3� Mark these locations with a pencil on the top and bottom rail�
Fig. 1
Mark here
Mark here
Step 2. Cut & Clean Panel
1� Cut rails using a saw with a fine tooth carbide cutting blade�
2� Use file to smooth cut edges�
3� Remove any metal shavings and dust with a brush or rag�
4� Make sure surfaces to be painted are clean�
8
Center of Panel
Half of panel lengthH alf of panel length
AL HOME VERTICAL CABLE INSTALLATION
13
Fig. 2
Mark here
Mark here
Not Here
Measure
from back of
bracket