Fortress Building Products Al13 HOME Instructions D'installation page 17

Step 2. Flat ATR Line And End
1� Measure the distance from the inside edge of the 2 posts�
2� Cut the ATR to measured length�
3� The ATR cannot block the inside edge of the post�
4� When test fitting the ATR, place on top of the spacers� Do not
press the ATR down over the spacers� Removing the ATR from
the spacers can damage the ATR and spacers�
5� Remove the backing of all of the double-sided tape on the ATR
spacers�
6� A Rubber Mallet might need to be used to install� If using a
rubber mallet, use a cloth to protect the ATR from damage�
Fig. 1
Fig. 2
ATR should not go past
this point when test fitting
Step 3. Flat ATR Corner
1� When installing ATRs on corners with a 2" [51mm] post, the
ATR must be 5/16" [8mm] away from the post� As shown in
Fig� 1�
2� If installing a corner with a 3" [76mm] proud post, install the
ATR at full length from the inside edge of the post to the inside
edge of the post� As shown in Fig� 2�
AL
Fig. 3
ATR Cannot
Go Past This Line
HOME VERTICAL CABLE INSTALLATION
13
ATHENS FENCE INSTALLATION
17