Fortress Building Products Al13 HOME Instructions D'installation page 13

Note:
• DO NOT REMOVE BACKING OF DOUBLE SIDED TAPE
UNTIL YOU ARE READY TO PERMANENTLY ATTACH
THE ATR.
Fig. 1
Spacer attached
next to bracket
Fig. 2
Double Sided
Step 2. Round ATR and End Posts
1� Measure the distance from the inside edge of the 2 posts�
2� Cut the ATR to measured length�
3� The ATR cannot block the inside edge of the post� As shown in
Fig� 3�
4� When test fitting the ATR, place on top of the spacers� Do not
press the ATR down over the spacers� Removing the ATR from
the spacers can damage the ATR and spacers� As shown in
Fig� 2�
5� Remove the backing of all of the double-sided tape on the ATR
spacers�
6� A Rubber Mallet might need to be used to install� If using a
rubber mallet, use a cloth to protect the ATR from damage�
AL
Tape
HOME VERTICAL CABLE INSTALLATION
13
ATHENS FENCE INSTALLATION
[279.5mm]
14"
Max
13