Fortress Building Products Al13 HOME Instructions D'installation page 34

Fig. 2
Step 3. Install Panel
1� Use level to ensure that all panels are at the same height
before attaching them to the post�
• The use of an ATR Spacer or block might be needed to
measure over a post�
Fig. 1
Step 4. Apply Screws
1� Attach the panel to each of the 4 brackets using the provided
self-drilling screw with a T-25 Bit�
Tip: Pre-drill with a 3/16" [4.5mm] drill bit.
Note:
• It is recommended that all panels are attached with
provided screws on the same side of the bracket
when using a line post. As shown in Fig.1.
• Only one screw is needed to secure the bracket to
the panel.
34
Fig. 2
AL HOME VERTICAL CABLE INSTALLATION
13