Fortress Building Products Al13 HOME Instructions D'installation page 16

OTP: FLAT ACCENT TOP RAIL (ATR)
Step 1. Flat ATR Spacers
1� Measure distance between brackets and cut ATR spacer to
length� The spacer can be 1/4" [6�5mm] shorter than the
distance between brackets�
2� If one of the screw holes was cut off during the sizing of the
ATR spacer, use a 5/8" [16mm] drill bit to add another hole
1" from the end of the ATR spacer�
3� Attach the ATR spacer using the provided self-drilling screws
with a 5/16" [8mm] nut driver�
4� All screw holes must have a screw installed�
Note:
• Flat ATR uses a full length ATR spacer.
• DO NOT REMOVE BACKING OF DOUBLE SIDED TAPE
UNTIL YOU ARE READY TO PERMANENTLY ATTACH
THE ATR.
Fig. 1
Fig. 2
Double Sided
16
Tape
AL HOME VERTICAL CABLE INSTALLATION
13