Rear-Facing Installation; Luas Installation - Britax MARATHON Guide D'utilisation

BRITAX Child Safety, Inc.

Rear-Facing Installation

LUAS Installation

1. Remove the lower
connectors from the
storage slots in the base.
Press the adjuster release
button and pull the strap
to full length. Repeat for
the second strap.
2. Recline the unoccupied
child seat to position 3 and
place rear-facing on the
vehicle seat (see page 25).
3. Firmly press the lower
connectors onto the
adjacent lower anchors
until a click confirms
attachment.
4. Push the child seat
down while pulling each
lower connector strap to
tighten.
5. Attach the Versa-Tether
to a designated anchor
(see vehicle owner's
manual) and remove
slack (see page 28).
Store the excess webbing
in the elastic strap.
IMPORTANT: The
Versa-Tether MUST be
used at all times when
installing this child seat.
8
a
or
b
Rear-Facing Installation with LUAS
9 Check that all connections are secure and straps are not
twisted.
9 Check that the child seat cannot be moved front to back
or side to side more than 2.5 cm (1 in.) at the belt path.
If the child seat is not secure, repeat installation or use a
different seating location.
9 Check that the back angle of the child seat is 30° – 45°
from vertical (not to exceed 45°) when the car is parked
on a level surface. See "Seat Positions" on page 25.
MARATHON Canadian User Guide
9