EIBENSTOCK EBS 235.1 Notice Originale page 24

Replacement of the Grinding Shoes:
Step 1: loosen both locking screws M6x6
Step 2: demount the clamping ring (lever out of the guide slot by using
screwdriver or similar)
Step 3: remove the grinding shoes and replace by new grinding shoes
Step 4: mount the clamping ring like shown below
Step 5: screw in both locking screws M6x6
The opening of the clamping ring has to be positioned centric between
the both locking screws and the ring has to lie completely inside the
guide slot. The heads of the locking screws have to be flush with the
base plate and may not touch the clamping ring (see detailed photos
below).
2 locking screws M6x6
Let the machine run for a short period of time and in a safe position. If the
machine does not run easily, stop working immediately.
Use only original accessories!
24
!
clamping ring