EIBENSTOCK EBS 235.1 Notice Originale page 22

Dust Extraction
5
Instruction for Use
Attention! Check the correct fit of the sanding shoes before each use!
Connect the tool to an appropriate dust extraction.
Switch the machine on and put the machine carefully on the surface.
Guide the tool with both hands. The concrete grinder can be moved pushing
and drawing across the surface.
Check in regular intervals the wear of the diamond segments.
On hard floorings you need some abrasive dust on the surface to sharpen
the diamond segments faster.
Therefore it suffices to switch off the connected industrial vacuum cleaner for
few seconds.
Or the surface can be wetted during grinding to reduce the "polishing" of the
diamond segments.
Take care that approx. 20 to 30 per cent of the grinding wheel works on the
already grinded surface to avoid scoring and to get a better grinding result.
This method also avoids polishing of the diamond segments.
Grinding near to the edge:
10
Dust which occurs during your work is hazardous to health.
That is why the machine must be used with a vacuum
cleaner (dust category M), and a dust mask has to be worn.
The suitable Wet/Dry Vacuum Cleaner DSS 35 M iP is
available as accessory. It can directly be attached to the
connection (5) on the floor guiding device.
For grinding at egdes (f.e. on walls,
thresholds, edges of the base...) a segment
from the protection cover (10) can be
removed.
Loos the 2 screws with the included Allen
key SW 8 and slide the segment of the
protection cover. The assembly of the
segment is in reverse order
22