EIBENSTOCK EBS 235.1 Notice Originale page 23

For grinding near to the edge the handle has to be adjusted accordingly
(see handle adjustment).
Attention! For all other works you always have to work with the
complete protection hood!
! Attention!
Do not touch rotating parts!
Before the beginning of all works disconnect the plug from the mains!
Changing the Diamond Grinding Wheel
Attention!
The grinding wheel might heat up enormously during operation. You
could burn your hands or get cut or ripped by the segments. Therefore,
always use protective gloves when changing the grinding wheel.
Before any work on the tool, disconnect the plug from the mains!
Put the flooring guiding device upright.
For changing the grinding wheel put down the machine in that way that no
damages can occur.
Changing of the diamond grinding wheel (37117000) and the base plate
(37120000):
Put the grinding wheel or base plate (7) from his connection.
Before mounting a new grinding wheel or base plate clean the spindle
connection.
Mount the new diamond grinding wheel or base plate the other way round!
For mounting the new grinding wheel or base plate always use the new
screws included in delivery of the accessories. These are equipped with a
screw locking against unintentional loosening.
Open the 6 cheese-head screws M6x25
(8) with the Allen key SW 5 included in
delivery of the grinding wheel or base
8
plate.
For easier
workspindle with an Allen key SW 8
through the opening in the middle of the
7
ventilation shroud of the motor.
23
changing lock the