EIBENSTOCK EBS 235.1 Notice Originale page 19

Let it run idle for about 30 seconds in a safe position. If considerable
vibrations occur or if other defects are recognised, switch off
immediately.
Always lead the mains and extension cable as well as the extraction

hose to the back away from the machine.
Power tools have to be inspected by a specialist in regular intervals.

Do not touch rotating parts.

Personen unter 16 Jahren dürfen das Gerät nicht benutzen.

During use, the operator and other persons standing nearby have

to wear suitable ear protectors, a dust mask and protection
goggles.
Make sure that persons in the work space are not endangered by

particles flying around.
Keep the handles dry, clean and free of oil and grease.

Always carry the tool at the transport handle (1) intended for it. Therefor

put the floor guiding device in upright position.
Attention! The tool still runs for a little while after the machine was

switched off.
For further safety instructions, please refer to the enclosure!
Floor guiding device
Handle assembly
3
Before initial operation the handle (2)
has to be mounted to the floor guiding
device.
Put the handle through the fastening
2
clamp at the device, fix it with allen
screw (3), following push the rubber
handle onto the tube.
Using a rubber mallet, carefully hit on
the rubber handle until it is completely
on the tube.
19