Commissioning And Maintenance; Releasing The Transducer; Instruments Admissions; Agency Approvals - OHIO SEMITRONICS DCTR-005D Mode D'emploi

6. Commissioning and maintenance

Switch on the power supply and the measuring input. It is
possible during the operation to disconnect the output line and
to connect a check instrument, e.g. for a functional test.
No maintenance is required.

7. Releasing the transducer

Release the transducer from a top-hat rail as shown in
Fig. 8.
Fig. 8

8. Agency approvals

CSA approved for USA and Canada
file-nr. 204767
FCC Compliance and Canadian DOC Statement
This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to both
part 15 of the FCC Rules and the radio interference regu-
lations of the Canadian Department of Communications:
These limits are designed to provide reasonable protec-
tion against harmful interference when the equipment is
operated in a commercial environment. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in
a residential area is like to cause harmful interference
in which case the user will be required to correct the
interference at his own expense.
7004-00064-A Rev --.indd

9. Dimensional drawing

112.5
114.1
Fig. 9. Housing type P13/70 clipped onto a top-hat rail
(35 ×15 mm or 35×7.5 mm, acc. to EN 50 022).
Page 11 of 12
10 11 12 13
1 2 3 4 5 6 7 8 9
70
8/12/09