Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
If you have followed the instructions carefully and your faucet still does not work properly, take the following corrective steps:
PROBLEM
Leakage under the
handle
The aerator has an irregular
or reduced water
Water will not shut off
completely
There is leaking from the
sink drain at the base of
the sink.
There is a low fl ow of
water.
Care & Maintenance
*
To keep the product clean & shining, follow the steps below:
1.
Rinse with clean water & dry with a soft cloth
2.
Do not clean with soaps, acid, polish, abrasives or harsh cleaners
3.
Do not use cloth with a coarse surface
4.
Unscrew the aerator and clean when necessary
*
This installation manual is subject to change without further notice.
14
CAUSE
Bonnet nut (9) has
come loose
The aerator is dirty or
mis- fi t ted
Cartridge may need to
be adjusted or replaced
The sink has a rough or
irregular surface
The fi l ter washer in the
hose connectors is dirty
ACTION
Remove the index (13). Loosen screw (12)
with hex wrench (20). Remove the
handle (11). Unscrew cap (10) (by hand
only). Tighten bonnet nut (9) with an
adjustable wrench.
Remove the aerator and check for debris.
Ensure that the rubber washer is properly
installed.
Remove the index (13). Loosen screw (12)
with hex wrench (20). Remove the
handle (11). Unscrew cap (10) (by hand
only). Tighten bonnet nut (9) with an
adjustable wrench. Remove the cartridge
(8). Check for cracks.
Apply additional silicone sealant to the
beveled side of the drain ange. Retighten
and test for leaks.
Turn off the water supply at water valve
and unscrew the hose connectors from
water supply lines. Clean the fi l ter washer
in the water lines with hot water, removing
any debris or calcium build up.
ACID
Publicité
Table des Matières
