Dyson V11 Manuel D'utilisation page 7

Charging and storing
your machine
It's important to fully charge your new machine before
using it for the first time, and after every clean. This is
because the battery and monitoring system's algorithm
3-4.5hrs
'learns' over time, and fully charging your machine
helps it to more accurately calculate and display
remaining run time.
Connect to the charger either directly
or in the docking station.
The blue LEDs on either side of the
battery will flash during charging.
When the battery is fully charged,
both LEDs will light for 5 seconds.
Your battery is fully charged when
the display shows 100%.
Emptying your clear bin
2
Be careful not to pull the power trigger
while the clear bin is open for emptying.
Eco
100%
Your machine won't operate if the
ambient temperature is below 0°C
(32°F). This is designed to protect
both the motor and battery.
English
Espanol
Changing your battery
Where you have additional batteries, we
recommend that you alternate the batteries to
maintain even performance.
Auto Med
To remove a battery
Hold your hand under the
battery to support it.
Press the battery release
Low
button and slide the battery
run time
off the handle.
4:50
Place the battery on charge.
English
3
clik
clik
Close the clear bin by pushing the bin base
upwards until the clear bin and bin base click
into place.
Boost
clik
To install a battery
Slide the battery onto
the handle until it clicks
securely in place.
Auto
On
English
Off
selected
Exit
1
clik
clik
clik clik
7