Topcom BABYTALKER 3100 Manuel D'utilisateur page 11

Babytalker 3100
Problem
'NOT LINKED' appears
on the parent unit
display
The parent unit does
not reproduce the
sounds picked up by
the baby unit
Limited range and
interference during
transmission
The equipment emits a
high-pitched whistle
11.3 Registering the Parent Unit with the Baby Unit
If the night light of the baby unit blinks and/or no connection can be established between the parent unit and the
baby unit (blinking green LED
• Check that the AC mains adapter of the baby unit is connected and plugged into a mains
receptacle and that the batteries in the parent unit are charged.
– Unplug the AC mains adapter of the baby unit from the mains receptacle and remove the batteries from
the parent unit.
– Press the On/Off switch
the mains receptacle.
The baby unit will start up in registration mode.
– Release the On/Off switch
– Press the On/Off switch
The parent unit will start up and the 1 volume -
On/Off switch .
15
– Registration mode ends after successful registration or after 60 seconds.
The night light
The LEDs of the parent unit will go off.
– You will hear a long beep when registration is successful or three short beeps if it is not.
Checking the link between the parent unit and the baby unit:
– Press and hold the Paging button
– In response, the parent unit will emit a high-pitched tone for 30 seconds.
– Briefly press the On /Off switch
12 Storage and Disposal Instructions
• We recommend that you keep the box and packing materials so you can use them to
transport the equipment in the future if necessary.
12.1 Storage
Remove the batteries (regular or rechargeable) from the parent unit and the baby unit.
Store the equipment in a dry location.
12.2 Waste Disposal of Package Materials
The package materials are environmentally friendly materials that can be given to your local waste collector
for recycling.
12.3 Waste Disposal (environmental protection)
Possible cause
Baby unit not switched on
The parent unit and baby unit are too
far apart
The parent unit is not registered with
the baby unit
The volume setting of the parent unit
may be too low or switched off.
Short sounds are not heard
The range of the equipment depends
on the surroundings.
Steel structures and concrete walls
can impair transmission.
The parent unit and baby unit are too
close together
13
on the parent unit), the parent unit needs to be registered with the baby unit.
4
of the baby unit and hold it pressed while plugging the AC mains adapter into
4
. The night light
15 of the parent unit and hold the button pressed while installing the batteries.
of the baby unit will stop blinking;
on the baby unit for 2 seconds.
5
15 on the parent unit to switch off the tone.
Switch on the baby unit
Reduce the distance between the
parent unit and the baby unit
Register the parent unit with the baby
unit (see "11.3 Registering the Parent
Unit with the Baby Unit")
Increase the volume setting of the
parent unit
Turn off the NEMo function
Avoid obstacles as much as possible.
Increase the distance to at least
2 metres
of the baby unit will blink for 60 seconds.
11
, the power 17 and link-LED
Solution
will blink. Release the
13
9