Modelling Light (Ml) - Metz mecablitz 44AF-2 digital Mode D'emploi

Flash
Masquer les pouces Voir aussi pour mecablitz 44AF-2 digital:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 35
(depending on the camera type) on the
camera or by the camera's master is
possible.
For slave flash unit 44AF-2, slave group
A as well as all remote channels 1, 2, 3
and 4 are always set.
Configuration procedure for remote
slave flash mode
• Switch on the flash unit by pressing
the button
• Press the "SL"
unit to configure the remote slave SL
flash mode. The setting is effective
immediately and saved automatically.
Checking the remote flash mode
• Position the slave flash unit accor-
k
ding to subsequent shooting require-
ments.
A flash unit stand S60 (accessories)
should be used when setting up the
slave flash unit.
• Wait until all involved flash units are
ready. When flash readiness is achie-
ved for the slave units, the AF measu-
ring beam
118
.
button on the flash
will start flashing.
+
• To release a test flash, press the
manual firing button
or controller flash unit. The slave
flash units will respond with a test
flash. Should a slave not respond,
+
adjust the position of the slave so
that the slave sensor f can receive
light from the master or controller
flash unit.

8 Modelling light (ML)

+
Modelling light is only possible if the
function is integrated into the camera.
Modelling light (ML) uses a high fre-
quency strobe light.
It gives the impression of quasi conti-
nuous light for 3 seconds.
SL
M
Modelling light allows you to evaluate
light distribution and shadow prior to
the shot.
TTL
LED
Modelling light is activated via the
camera.
on the master

Publicité

Table des Matières
loading

Table des Matières