Technical Specifications - Nicols EYES 2 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Disconnect the mains power if the fixture is has not been used for a long time.
DO use the original packing materials before transporting it again.
Caution:
To prevent or reduce the risk of electrical shock or fire, do not expose the unit to rain or moisture.
Hot lamp explosion hazard. Do not open the unit within 15 minutes after switching off.
DO replace the bulb once it is damaged, deformed or life-expired.
DO NOT look directly at the light while the bulb is on.
Never touch bulb with bare fingers, as it is very hot after using.
DO NOT start on the unit without bulb enclosure or when housing is damaged.
Mounting:
-Hanging
The product can be mounted in a hanging position using the supporting bracket. The bracket should be secured
to the mounting truss or structure using a standard mounting clamp. Please note that when hanging the unit a
safety cable should also be used.
-Upright
The product can be mounted in an upright or sitting position using the supporting brackets.
-NOTE:
The product can be mounted at any angle and in any position. It is possible to further adjust the angle of the
product using the two adjustment knobs located on the side of the fixture.
The unit should be mounted by its screw holes on the bracket. Always ensure that the unit is firmly fixed to
avoid vibration and slipping while operating. The structure to which you are attaching the unit should be able to
support 10 times the weight of the unit. Also always use a safety cable that can hold 12 times the weight of the
unit when installing the fixture.
The equipment must be fixed by professionals.

TECHNICAL SPECIFICATIONS

Voltage: AC100-240V, 50/60Hz
Power: 230W
Light Source: 12x15W RGBWA + UV 6 in 1 LED bar
Lumens : 2550LUX@2M
Dimming: 0-100% / Strobe
DMX channels : 1/2/6
Control mode: Auto, DMX, Master/Slave, Manuel
Beam angle: 60°
Net Weight:3,7Kg
Dimensions : 395*190*253mm
9-

Publicité

Table des Matières
loading

Table des Matières