Timestamp Of The Data; Operation Of The Led - ADEUNIS LoRaWAN Smart Building COMFORT Guide Utilisateur

LoRaWAN Smart Building COMFORT - Guide utilisateur / User guide version V2.1.1

2.4. Timestamp of the data

The sensor can integrate the timestamp of the data in the frame if this option is
activated. Timestamp is given in EPOCH 2013 (please, refer to the TRM of the
product to know the content of each frame).
To configure the timestamp, you have to set the UTC time first, via Downlink or
through the Advanced Menu of the IoT Configurator.
Then you an activate the timestamp in the Applicative parameters and choose if
you want to set the timezone and if you want that the product take into account
the Daylight Saving Time.

2.5. Operation of the LED

Mode
Product in Park mode
Push button detection in PARK mode
Product start (after detection of the push
button)
Joining process (LoRaWAN products)
Network Quality test running
Network Quality test result
Switching to the Command mode
Battery level low
Product faulty (return to factory)
Button press in OPERATING mode
* The green and red LED lights simultaneously give a white/yellow rendering through the case.
LEDs scenario for a sensor configured in Class A OTAA :
JOIN process :
LED blink successively
every seconds
Red LED state
OFF
OFF
OFF
During the JOIN phase: flashing: 50ms on
/ 1 s off
If the JOIN phase is complete (JOIN
accept):
flashing: 50ms on / 50ms Off (6x)
10 to 20 seconds ON
Bad coverage : 10 seconds ON
Medium coverage : 10 seconds ON
Good coverage : OFF
Continuously lit*
Flashing (0.5s ON every 60s)
Fixed ON
ON for 500 ms *
JOIN ACCEPT :
LED blink successively
every 50 ms
Green LED state
OFF
ON from detection of the event during 5 seconds
Rapid flashing 6 cycles, 100 ms ON / 100 ms OFF
During the JOIN phase: flashing: 50ms on / 1 s off
(just after the red LED)
If JOIN phase is complete (JOIN accept):
flashing: 50ms on / 50ms off (just before the red LED)
10 to 20 seconds ON
Bad coverage : OFF
Medium coverage : 10 seconds ON
Good coverage : 10 seconds ON
Continuously lit*
ON for 500 ms *
Network test: Network test result:
LEDs during During 10 seconds
10 to 30 seconds
Orange = Medium, Red =
Green= Good,
Bad
Page 49
FR
EN
of 51