Electronic Clock; Electronic Timer - M-system BPRF 960 Mode D'emploi

ELECTRONIC CLOCK

The programmer is equipped with an
electronic clock with an illuminated dis-
play which indicates hours and minutes.
Upon immediate connection of the oven
or after a powercut, three zeros will flash
on the programmer panel.
To set the hour it is necessary to push
the button and then the
button until you have set the exact hour
(fig. 5.2).
Another way is to simultaneously push
the two buttons and at the same
time push the
Note: The hour setting deletes any pro-
gram.
NORMAL COOKING WITHOUT THE
USE OF THE PROGRAMMER
To manually use the oven, that is, without
the aid of the programmer, it is necessary
to cancel the flashing AUTO by pushing
the button (AUTO will be switched off
and the symbol
Attention: If the AUTO is steadily lit (which
means a cooking program has already
been set), the program can be cancelled
and switched to manual by pushing the
button .
If the oven is switched on, you must
switch off manually.
Fig. 5.3
90
(fig. 5.2)
or
or button.
will go on - Fig. 5.3).

ELECTRONIC TIMER

The timer program consists only of a
buzzer which may be set for a maximum
period of 23 hours and 59 minutes.
If the AUTO is flashing push the
ton.
To set the time, push the
the or until you obtain the
desired time in the panel (fig. 5.4).
Having finished the setting, the clock
hour will appear on the panel and the
symbol will be lit.
The countdown will start immediately and
may be seen at any moment on the panel
by simply pressing the button
At the end of the time, the
will be switched off and an intermittent
buzzer will go off; this can be stopped by
pressing any of the buttons.
SETTING THE FREQUENCY OF THE
AUDIBLE SIGNAL
3 possible sounds can be selected by
pressing the button.
A
U
T
O
Fig. 5.4
but-
button and
.
symbol