M-system BPRF 960 Mode D'emploi page 111

CONNECTING THE FEEDER CABLE
To connect the feeder cable to the cook-
er it is necessary to:
- Remove the screws securing the
cover "A" on the rear of the cooker
(fig. 9.1).
- Feed the supply cable through the
cable clamp "D". The supply cable
must be of a suitable size for the
current requirements of the appliance;
see the section "Feeder cable
section".
- Connect the wires to the terminal
block "B" as shown in the diagram in
figure 9.2; or connect the phase wires
to the terminal block "B" and the earth
wire to the terminal PE as shown in
figure 9.1.
– Pull the feeder cable and block it with
the cable clamp D.
– Re-mount shield A.
N.B. The earth conductor must be left
about 3 cm longer than the others.
B
A
Fig. 9.1
PE
N
D
L
FEEDER CABLE SECTION
Type "HO5RR-F"
230 V 3 x 1,5 mm
230 V
L
1
(L
Fig. 9.2
2
N PE
)
2
111