Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CHOICE OF THE BURNER
On the control panel, near every knob,
there is a diagram that indicates which
burner is controlled by that knob.
The suitable burner must be chosen
according to the diameter and the
capacity used.
As an indication, the burners and the
pots must be used in the following way:
BURNERS
Auxiliary
Semi-rapid
Rapid
Triple-ring
do not use pans with concave or convex bases
AIR FLOW
(cooling fan)
POT DIAMETER
12 - 14 cm
16 - 24 cm
24 - 24 cm
26 - 28 cm
AIR FLOW
(cooling fan)
CORRECT USE OF RAPID BURNER
It is important that the diameter of the
pot be suitable to the potentiality of the
burner so as not to compromise the high
output of the burners and therefore
energy waste.
A small pot on a large burner does not
give you a boiling point in a shorter
amount of time since the capacity of
heat absorption of a liquid mass
depends on the volume and the surface
of the pot.
Fig. 3.3
AIR FLOW
(cooling fan)
Fig. 3.4
81
Publicité
Table des Matières
