Getting Started; Attaching The Hoses - ULTIMATE SPEED 12 V UOP 12 C1 Instructions D'utilisation Et Consignes De Sécurité

Store the appliance and the
used oil in a dry place and out
of reach of children .
Dispose of used oil and soaked
rags properly (see "Disposal") .
In order to protect the
environment, do not let oils drain
into the ground or household
drains .
Never use a damaged
appliance! Disconnect the
appliance from the vehicle
and contact your retailer if it is
damaged .
Never use accessories which
are not recommended by the
manufacturer . They could pose
a safety risk to the user and
might damage the appliance .
Only use original parts and
accessories .
This product has been classified
as IPX4 and is protected against
splashing water from any
direction . Do not immerse in
water .
22 GB/IE
mCAUTION! Do not immerse the
electrical parts of the appliance
in water or other liquids . Never
hold the appliance under
running water .
To prevent damage, let
the appliance cool for at
least 10 minutes after
every 30 minutes of
continuous operation.
˜ Getting started

Attaching the hoses

1 . Remove the protective caps 7 (fig . A) .
2 . Straighten the suction hose 9 and the drain
hose 11 .
3 . Put the hose clamp 10 to the end of the suction
hose (Ø 6 mm) 9 . Plug the suction hose end
onto the suction hose connector 8 .
4 . Put the hose clamp 10 to the end of the drain
hose (Ø 12 mm) 11 . Plug the end of the drain
hose onto the drain hose connector 6 .
5 . Fasten both hose clamps 10 . Make sure the
hose clamps are fitting tightly on the hose .
6 . Pay attention to the pumping direction
on the appliance .
m
Make sure that the hoses 9 , 11 are
straightened to avoid damage.