Setting Up The Transporter - Munchkin brica SmartMove Notice D'utilisation

SETTING UP THE TRANSPORTER

EXTEND THE HANDLE
Press the handle release button on the underside of the telescoping handle and pull
upward until it locks into position. Three locking positions are available for varying heights.
UNFOLD PLATFORM AND WHEELS
Holding the handle upright, push the platform down to the floor with your foot.
The wheels will swivel open at the same time.
POSITION THE ADJUSTABLE BAR
Place the child safety seat onto the
platform with the back of the seat against
the transporter. The seat should be flat on
the platform. (Some child safety seats may
require the removal of a recline block.)
Press the release button on the adjustable
bar to raise or lower the strap until it is
directly behind the seat's belt path. Four
locking positions are available.
Refer to your child safety seat user guide
for belt path location.
RELEASE THE STRAP
Remove the strap from the buckle by pinching the buckle's release tab, (Fig. a) while
pulling the strap loose.
Fig. a
To release
Car seat
belt path
Fig. b
To tighten
How to Install Included Parts
5