Installing The Booster Chair - Munchkin Boost 10821 Notice D'utilisation

How to Use

INSTALLING THE BOOSTER CHAIR

1. Press the fold release buttons at the same time to unlock
the tray and legs.
2. Separate the front and back legs by pulling them apart.
Then, push the tray up until it snaps into place.
3. Tilt the backrest backward. Then push the folding seat down until it snaps into place.
3a
4. Check the adult chair size to ensure that it has a larger
width, depth and height than the booster seat.
The seat width and depth must be 4" (10 cm) larger
than the booster seat base dimensions.
Then, place the booster on the chair.
6
1
2
3b
4
NOTE: Ensure that the seat is horizontal. If necessary, extend any of
the booster's feet by twisting counterclockwise. Do not use the feet
to make the booster taller.
5. Buckle the upper anchor strap around the chair's backrest. Tighten the strap to remove
all slack. The backrest must be 4" (10 cm) higher than the upper anchor strap.
5a
6. Secure one end of the lower anchor strap to a hook clasp on the front leg. Guide the
strap under the chair's seatrest and secure the hook to the clasp on the opposite side.
Tighten the strap to remove all slack.
6a
5b
6b
How to Use
7