Activating And Setting The Date/Time; Attaching The Cuff - uebe Visomat Comfort Eco Mode D'emploi

B

6. Activating and setting the date/time

The unit has a date/time function which you can activate where necessary. This
function is deactivated when the unit is delivered.
Activating the date/time function
To activate the Date/Time function, press and hold down the Start/Stop button until
the full display is shown, and also press the Memory button. The function can be
deactivated again at any time in the same way.
Setting the date/time
The four-digit number representing the year appears in the
display first (Fig. 1). Press the Memory button to set the year.
Press the Start/Stop button to confirm the selected year and
proceed to setting the date.
Set the month with the Memory button and confirm this
with the Start/Stop button. Set the day, hours and minutes
in the same way (Fig. 2, Fig. 3).
Changing the date/time
To change the date/time function, take out a battery and
wait until the display goes blank. Now you can reactivate
the date/time function and reset the date and time again.
Deactivating the date/time function
To deactivate the Date/Time function, press and hold down
the Start/Stop button until the full display is shown, and also
press the Memory button.
When the date/time function is activated, the time is also
shown in the display when the unit is switched off.
EN-38
Operating the unit
Fig. 1
Fig. 2
Fig. 3
Operating the unit

7. Attaching the cuff

• Expose the upper arm.
• Push the cuff onto the upper arm until the lower
edge of the cuff is 2-3 cm above the crook of the
arm (Fig. 1, Fig. 2).
• When using the unit on the left arm, the air hose
runs to the unit through the middle of the crook
of the arm so that the 4 cm long artery marking
is automatically located centrally above the pulse
position (Fig. 3).
• When using the unit on the right arm, the cuff
must be rotated to the left until the artery marking
is on the pulse position. The air hose then runs
along the inside of the upper arm (Fig. 4).
• The cuff should be tightened to such an extent
that 2 fingers can still be inserted between arm
and cuff. Tip:
– Bend your arm slightly.
– The upper arm muscle is tensioned slightly.
– This slightly increases the circumference of the
arm.
• Now pull the free cuff end tight and close the
Velcro fastener (Fig. 5).
• Check if the measurement arrow on the cuff is
inside the „marking for arm circumference" at the
edge of the cuff.
B
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
EN-39