Installation Instructions - Burg Wächter Door eGuard Mode D'emploi

Dear customer,
thank you very much for deciding for Door eGuard
manufactured by BURG­WÄCHTER. Door eGuard is
a battery­operated system with a camera and colour
monitor, easy to install and providing its user with the
certainty of being able to see anything happening
outside the entrance door without being seen. Thanks
to its large adjustment range, this door spyhole can
be used with any common door with a thickness
from 38 to 110 mm. The camera optics can cover
existing holes in the door of 14 – 26 mm. Thanks to
the camera optics with a large viewing angle, even
persons hidden near the door can be identified.
Important: Please read the entire User
Manual before you start to mount the device.
Let us wish you a high level of security and
quality of living with your electronic spyhole.
Your BURG­WÄCHTER KG

Installation instructions

1. Replace the existing door viewer or drill a 14mm
2. Peel off the 3M sticker top layer on the holding plate
uard Door eGuard
hole in the door at the required height. Peel off the
3M sticker top layer and then insert the camera
from the outside. Ensure the door bell button is
under the camera and adjust the camera vertically to
the ground (FIG.1)
and fit the holding plate over the end of the camera
wires on to the back of the door. Make sure the
arrow on the holding plate points upwards. Then
screw up the locking barrel on to the back of the
camera. This will hold the plate to the door (FIG.2)
English | 21