Connection Notes; Heating Connection; Transportation - Würth LATENTO 500 Notice De Montage

6. Connection notes

Warranty
IVT GmbH & Co. KG will exclusively assume warranty for the functionability of
the LATENTO only then if all notes described in this chapter are observed.

Heating connection

It is essential to take care of professional bleeding (e.g. automatic bleeder) when
connecting the LATENTO to the heat generator/s.
Caution If there are steel pipes used in the cold water supply or in the
heating grid, beware of the danger of getting steel blades in
the drinking water heat exchanger. This has to be prevented
by using a filter, otherwise there may be a contact corrosion,
causing a permeable drinking water heat exchanger.

6.1 Transportation

The LATENTO must always be delivered in a standing position
Note
so as to avoid any damage! The LATENTO may be tilted max.
horizontally for a short time, e.g. when carrying it to the place
of installation. Great care must be taken that the cover was
closed with all screws.
25