Connection Notes; Heating Connection; Transportation; Mounting - Würth LATENTO XP 500 Notice De Montage

5. Connection notes

Warranty
IVT GmbH & Co. KG will exclusively assume warranty for the functionability of
the LATENTO XP only then if all notes described in this chapter are observed. In
particular heed the correct hydraulic integration of the LATENTO XP: The warranty
applies exclusively for that LATENTO XP that has been connected following an
installation proposal. The responsibility will be with the planning or executing
company in case of a hydraulic connection of the LATENTO XP deviating from this.

5.1 Heating connection

It is essential to take care of professional bleeding (e.g. automatic bleeder) when
connecting the LATENTO XP to the heat generator/s.

5.2 Transportation

Note
The LATENTO XP may be tilted max. horizontally for a short time, e.g. when car-
rying it to the place of installation. Great care must be taken that the cover was
closed with all four clamps.

5.3 Mounting

Heed the following points when selecting the installation site for the LATENTO XP:
Frost-protected room.
Level, clean swept floor.
do not subject the LATENTO XP to direct solar radiation
(the UV can destroy the plastic).
Heed the load capacity of the foundation, the filled LATENTO XP weighs approx.
580 Kg.
20
The LATENTO XP must always be delivered in a standing positi-
on so as to avoid any damage.