Hot Water Economiser Adjustment; Replacing The Clock Battery - Victoria Arduino VA358 White Eagle Manuel D'instructions

At the end of the adjustment process, refit the
sheet plastic guard on the relevant housing and
secure it in place with the two side screws. Refit
the drip tray and the work surface grid.
3.3 HOT WATER
ECONOMISER
ADJUSTMENT
NOTE: This operation can be carried out while
the machine is turned on.
All models VA358 are equipped with a hot
water mixer tap which adjusts the water tem-
perature and optimises the system's perfor-
mance.
To adjust the hot water economiser, turn the
registration knob.
• The hot water economiser is located inside
the machine;
• Turn the adjustment knob ANTICLOCKWISE
/ CLOCKWISE to INCREASE / REDUCE
the temperature of the hot water;
• when the operation has been completed,
screw the protective panel back on.
3.4 REPLACING THE
CLOCK BATTERY
The electronic control unit has a lithium battery
to power the clock; the battery has an autono-
my of about three years, after which it will need
to be replaced.
In case of an extended period of machine stop-
page, the clock can be stopped:
• with the machine that displays OFF:
CLOCK OFF
• hold the cleaning button until the emer-
gence of the written "disabled Clock".
WARNING
Replacement of the lithium battery must be
carried out EXCLUSIVELY by Qualified
Technician.
Simonelli Group cannot be held liable for
any damage to people or things due to non
observance of the safety prescriptions
Fig. 11
described in this booklet.
OFF
47