Troubleshooting - TOOLCRAFT T-HLP 2000 W Notice D'emploi

• As soon as the work is completed, press the On/Off switch (E) to position 0, pull out the mains plug and put the
product on its stand (F) to let it cool down. (Fig. 5)

9. Troubleshooting

By purchasing this heat gun, you have acquired a product design to the state of the art and operationally reliable.
Nevertheless, problems or errors may occur.
The following contains description for the removal of possible interference.
Always observe all safety information in these operating instructions.
• If your tool will not operate, check the power at the mains plug.
• If your tool is in electric leakage, pull the mains plug at once, and check whether the cable is damaged or whether
the tool is exposed to rain or wet conditions while working.
• If your tool has noise or abnormal shaking when operating, inspect all mounting screws and ensure that they are
properly tightened. Should any of the screws be loose, retighten them immediately. Should any of the screws be
lost, change new ones in the hardware shop.
G
C
Fig.4 Fig.5
21