Installation; Mounting - Goobay 71364 Mode D'emploi

User manual
5

Installation

• Let open cable ends ONLY assemble by experienced
electrician.
• Cut off power supply before any work on the product,
switch off safety fuse and secure against reconnection.
• Assure and check the absence of voltage before any
work on the product.
The power cord used should have a minimum cross section of 1.0 mm². The
following connections are made to the terminal block of the product.
1. Remove the cover cap.
2. Connect your lamps (LOAD) like shown.
If using several lamps, they must be wired in parallel.
Power cables are installable sidewise or from above.
Fig. 7: Installation
3. Fix all wire connections using a screwdriver.
4. Insulate the connection against contact and moisture.
The earth wire will not be connected.
6

Mounting

• Place and use tools safely.
• Pay attention to current-carrying or other
lines, lying behind plaster and do not damage them!
1. Select the mounting place according to the following criteria:
15
Risk of electric shock
Risk of falling / Material damage