Using The Appliance - Clatronic BS 1232 Mode D'emploi

5....-05-BS 1232
Overview of the Components
1 Cable
2 On/off switch
3 Vacuum power regulator
4 Carrying handle
5 Cable-winding key
6 Dust bag filling display
7 Hose connection
8 Vacuum hose
9 Handle for opening the dust bag
compartment
• Insert the connection head of the suction hose (8) into the hose connector (7)
until it locks in place. To do so, please press the buttons simultaneously. In order
to release the hose again, please press the buttons once more on the connec-
tion head.
• Keep the buttons pressed down and then pull out the hose.
• Please insert the sections of the 2-part suction tube (11) into one another and
then attach them to the handle section.
• Then assemble the floor nozzle (12) and/or the accessories.
1. Unwind the length of cable (1) you require.
2. Insert the mains plug into a correctly installed safety socket (230 V, 50 Hz) and
then switch the machine on using the on/off switch (2).
3. Set the vacuum power with the vacuum power regulator (3).
4. Vacuum at a steady speed. There is no need to exert pressure.
5. Attention: pay attention to the range that can be covered with the cable length.
Vacuum power regulator
Low vacuum power:
Medium vacuum power:
High vacuum power:
Cable winding device:
Pull out the cable (1) up to the maximum length indicated with the yellow mark.
Never pull the cable out up to the red mark as the cable winding can be damaged.
Said damages are not covered by the warranty.
19.02.2003 8:09 Uhr
Start-up
10 Dust bag compartment
11 Suction tube, 2-part
12 Floor nozzle
13 Hook on the suction tube (not
14 Parking assistance (not shown)
Accessories:
"2-in-1" nozzle (groove and brush nozzle)

Using the Appliance

For curtains and delicate fabrics
For long-pile velour carpets and textile flooring
For sturdy rugs and floors
Seite 35
shown)
GB
35